Waterline Technology AlwaysFresh H2O AP-UCBS-KIT, Инструкция по установке и эксплуатации

Страница: 12 / 20

Page 12
RE-SETTING AUTOMATIC BREW TIME: (FOR THE NEXT DAY)
Note: The clock must be set in order to have “Brew Start Time” functioning.
1.
Press and Hold the “PROGRAM” button for approximately 3 seconds to enter Program Mode. The colon (:) on the display will
begin to flash and a beep is emitted by the brewer to confirm that it is has entered Program Mode.
2. Press the “PROGRAM” button one (1) time. Display will show the default brew time (previous brew start time).
3. USING DEFAULT (PREVIOUS BREW START TIME): Press the desired “VOLUME SELECTION BUTTON” and press
“PROGRAM” button three (3) times to exit the Program Mode. Your brewer is now set.
4. NEW BREW TIME: Follow the above instructions (“SETTING AUTOMATIC BREW TIME”) steps 1 thru 6.
CHANGING BREW TEMPERATURE SETTINGS
Note: The Brewer brews coffee or water at a preset factory temperature setting of Level #2 (t2). The brewing temperature
can be adjusted lower or higher depending upon your personal preference. Level #1 (t1) is the lowest temperature setting
while Level #5 (t5) is highest. The temperature increment between each setting (t1 to t5) is about 2 to 3 degrees. This
coffee maker is designed to maintain an accurate brewing temperature and compensate at a certain degree for outside
influential factors.
Note: for high altitude areas we recommend a lower temperature setting.
1. Press and Hold the “PROGRAM” button for approximately 3 seconds to enter Program Mode. The colon (:) on the display will
begin to flash and a beep is emitted by the brewer to confirm that it is has entered Program Mode.
2. Press the “PROGRAM” button three (3) times. The display window will show the letter “t
°
” followed by a number. The number
(1 to 5) represents the current temperature setting of the unit.
3. To set temperature range, press and hold the plus (+) button or (-) button to scroll between t1 – t5.
4. After selecting the desired range, press the program button once to exit from the menu.
WARNING: Hot coffee or Hot water can cause serious burns. Make sure that the coffee or water has stopped coming out of the
brew cone before you remove it from the coffee appliance
.
HANDLE HOT COFFEE/WATER CAREFULLY AND PRACTICE CARE WHEN DRINKING
.
RESETTING YOUR BREWER TO FACTORY DEFAULTS
Note: Resetting the brewer to factory defaults will clear all settings previously programmed and restore default settings
programmed at the factory for brew volume and temperature range. Clock Time, Automatic Brew Time, Volume Selections
and Temperature Range Setting will be cleared.
TO RESET BREWER BACK TO FACTORY DEFAULTS
1. Turn the power OFF from the main power switch in the back of unit.
2. Press and hold “PROGRAM” button.
3. Keeping “PROGRAM” button depressed, turn the power ON from the main power switch in the back of the unit.
4. Release the PROGRAM button. Clock will flash and now read “00:00”.