Waterline Technology AlwaysFresh H2O AP-UCBS-KIT, Инструкция по установке и эксплуатации

Страница: 10 / 20

ADJUSTMENTS and PROGRAMMING YOUR Brewer :
(See Fig. 7)
(ALL MACHINES STARTING FROM SERIAL NO. 3432583 AND HIGHER)
SETTING THE CLOCK:
Fig. 7
1. Press and Hold the “PROGRAM” button for approximately 3 seconds to enter Program Mode. The colon (:) on the display will
begin to flash and a beep is emitted by the brewer to confirm that it is has entered Program Mode.
2. To set hours, press and hold the plus (+) button; hours on display will advance from 00 to 12pm. PM time is set when the green
dot is lit next to the “PM” in the upper left corner of the display box.
3. To set minutes press and hold the minus (-) button; minutes will advance from 00 to 59.
4. After setting the clock, press the “PROGRAM” button four (4) times to exit the Program Mode.
RESETTING THE VOLUME: (Amount of Coffee or water to be brewed)
NOTE: This machine is preset at the factory for the following settings:
FACTORY PRESET SETTINGS:
Volume Settings: Full Brew: (64 oz) 7:00 Minutes Half Brew (32 oz): 3:30 Minutes Qtr. Brew (16 oz): 1:45 Minutes
NOTE: When making volume adjustments, always insure an empty container with 64 ounces capacity is under the brew
cone and the power is ON. The volume of water dispensed, may vary slightly depending on water pressure or other
factors.
1.
Press and Hold the “PROGRAM” button for approximately 3 seconds to enter Program Mode. The colon (:) on the display will
begin to flash and a beep is emitted by the brewer to confirm that it is has entered Program Mode.
2.
Press the “PROGRAM” button two (2) times. The display window will now show “----“.
3.
Press the “FULL BREW SELECTION” button. Note the display will start counting minutes and seconds and water will start to
flow into the container. When desired volume has been reached, press the “FULL SELECTION” button to stop the water flow. If
more water is needed, press the “FULL SELECTION” BUTTON repeatedly until desired level is reached. After the
“SELECTION” button is programmed, press the “PROGRAM” button once to exit the Program mode.
4.
To program the “HALF BREW SELECTION”, follow steps 1 & 2 (above) using the “HALF BREW SELECTION” button. After the
“SELECTION” button is programmed, press the “PROGRAM” button once to exit the Program mode.
5.
To program the “QTR. BREW SELECTION”, follow steps 1 & 2 (above) using the “QTR. BREW SELECTION” button. After the
“SELECTION” button is programmed, press the “PROGRAM” button once to exit the Program mode.
Page 10