WATERKOTTE Basic Line BS 7006, Планирование и руководство по установке

Страница: 5 / 60

Safety
21.10.2015
5 / 60
Copyright

2014 by: WATERKOTTE GmbH. Subject to changes.
1 Safety
1.1 Intended use
Your WATERKOTTE heat pump of the Basic Line series is used for space
heating and cooling, and heating of domestic water.
An outdoor module, which is coupled to a heat source (air) that is available
year-round, serves as heat generator.
Project planning of the heat source system must be performed in compli-
ance with the technical information provided by WATERKOTTE for layout of
heat source systems. Heat pump shall only be turned on after the refriger-
ant connections are completely charged, and the other hydraulic circuits
are completely charged and vented, and all electrical connections are
properly completed.
Commissioning may only be carried out by trained professionals. Damages
caused by non-compliance with above mentioned items are not covered by
the warranty (see enclosed Exclusion of Warranty).
1.2 Basic safety precautions
1.2.1 Keep information available
In addition to the operating manual, also furnish operating instructions in
terms of Labour Protection Law and Work Equipment ordinance. Keep all
safety and operating signs on the heat pump in fully legible condition at all
times. Replace damaged or illegible signs immediately.
1.2.2 Before initial use
Before initial use of your WATERKOTTE heat pump, familiarise yourself with:

Operating and control elements of your WATERKOTTE heat pump

Equipment of heat pump

Operation of heat pump

Immediate surroundings of heat pump

Safety devices of heat pump
Before initial start, perform the following steps:

Ensure that all safety devices are installed and function as intended.

Check heat pump for visible damage. Eliminate any detected defects
immediately. Heat pump may only be operated in perfect condition!

Ensure that only authorised personnel is in the work area of the heat
pump and that no other persons are endangered when heat pump is
started.

Remove all objects and other materials that are not required for opera-
tion of the heat pump from the work area of the heat pump.

Activate the electrical connection; the module must be in standby mode
(oil sump heater active).

Check heating circuit temperature: Temperature heating circuit below
16 °C.