Waterite Fusion 2, Дополнение к руководству пользователя

Страница: 8 / 12

6
SETTING THE TIME OF DAY
STEP1U
STEP 1U – Press SET HOUR
STEP 2U – Current time: Set the clock to the closest hour by using the UP and
DOWN button. An arrow points to PM after 12. After a power outage, the time of
day will need to be reset. Press SET HOUR to exit.
NORMAL OPERATING DISPLAYS
When the system is operating one of two displays will be shown. Pressing UP or
DOWN buttons will alternate between the displays. One of the displays is always the
current time of day (to the nearest hour). The second display is the days remaining
until the next regeneration. If the days remaining is equal to one, a regeneration will
occur at the next preset regeneration time. The user can scroll between displays as
desired. If the system has called for a regeneration that will occur at the preset time
of regeneration, the arrow will point to Regen .
Regeneration Mode
Typically a system is set to regenerate at a time of low water usage...usually
overnight. If there is a demand for water when the system is regenerating, untreated
water will be used.
When the system begins to regenerate, the display will change to indicate the cycle
of the regeneration that is occurring and an arrow will also point to Regen . The
system will run through the steps automatically and will reset itself to provide treated
water when the regeneration is completed.
Manual Regeneration
Sometimes there is a need to regenerate the system sooner than when the system
calls for it.... usually referred to as a manual regeneration.
To initiate a manual regeneration at the preset delayed regeneration time,
simultaneously press the UP + DOWN buttons together and release. The arrow will
point to the word
Regen
if a regeneration is expected “tonight.” To cancel the
regeneration simultaneously press the UP + DOWN buttons and release.
To initiate a manual regeneration immediately, simultaneously press the UP +
DOWN buttons together for three seconds. The system will begin to regenerate
immediately. This cannot be cancelled. Note: For softeners, if brine tank does not
contain salt, fill with salt and wait at least two hours before regenerating.
Power Loss & Error Messages
If the power goes out current time of day will need to be reset. If the power goes out
while the system is regenerating, the cycle picks up where it was interrupted when
the power returns.
Note: The display will flash if a power outage has occurred.
If “E1,” “E2” or “E3” appears on the display contact a technical service person for
help. These indicate that the valve did not function properly.