All electrical connections must be carried out by a qualified electrician, according to the
local electrical codes. Always cut off the unit’s main power whenever the access panel is
open or removed. It is strongly recommended that the pool heat pump is installed outdoors
(unless approved by the manufacturer), while respecting the minimal clearances needed for
proper operation and heating. Please refer to “Location” on the following page
MAKE SURE THE INSTALLATION WAS CARRIED OUT ACCORDING TO THE
INSTRUCTIONS OF THIS MANUAL. SEE “INSTALLATION” SECTION.
MAKE SURE YOUR POOL HEAT PUMP WAS PROPERLY GROUNDED AND BONDED.
SEE “BONDING” AND “BONDING DIAGRAM” SECTIONS.
BEFORE ASKING FOR ASSISTANCE OR SERVICE, PLEASE READ CAREFULLY THE
SECTIONS ON “TROUBLESHOOTING ” AND “WARRANTY”.
!
VITAL
I pg 04
Pool Heat Pump
Proper pool chemistry is vital to the longevity of your pool heat pump. Pay particular
attention to the
total alkalinity and total dissolved solids.
It is highly recommended that
you have your pool chemistry checked often by an outside independent pool store. Your
pool water chemistry must be maintained at all times as shown in the table below to prevent
damage to your pool heat pump.
WARNING
!
IMPORTANT
DESCRIPTION
NORMAL RANGE*
VERIFY
PH Level
Chlorine Concentration
Total Alkalinity
Total Dissolved Solids
Calcium Hardness
7.4 to 7.8
1.0 to 4.0 PPM
100 to 120 PPM
below 1800 PPM
Reg. Pool
below 3500 PPM
Salt. Pool
200 to 300 PPM
1 per week
1 per 2-3 days
1 per 2-3 weeks
1 per month
1 per month
1 per month
* Warranty can be voided if not maintained within these ranges.
USAGE OF CHEMICAL PRODUCTS
Never add liquid chlorine, granular chlorine, or slow dissolving tablets/ pucks into the
skimmer basket. This high concentration of chemicals should be avoided.
Water quality standards that must be strictly adhered to*:
GENERAL SAFETY INSTRUCTIONS