Electrical connection of an automatic mode for the
pool and spa (for Smart Energy model only)
The Multi Function electronic control has the ability to switch from POOL to SPA mode
automatically .This function is used when warm water is directed towards the SPA.
Activation is carried out by using an external water pressure switch connected to the SPA
water line. This connection must be done by a qualified technician.
When the electronic control of the pool
heat pump is located inside the electrical
box
the 2 wires coming from the pressure switch
connected on the water piping going to the SPA
(as shown on the right) must be connected at the
boundaries of the electronic control of the pool
heat pump.
When the electronic control of the pool
heat pump is mounted on the front panel
of the unit:
The Orange and Orange-Black wires located inside the electric box junction
of the pool heat pump must be connected to the water pressure switch connected on the
water piping going to the SPA.
Electrical connection to an automation system to the pool (for Smart
Energy model only)
It is possible to carry out the connection of the Multi Function
electronic control to an automation system for models P4 or P8.
This type of connection
must be done by a qualified technician to ensure that your warranty will not be voided.
For automation system operation, you will need to set the SPA temperature to maximum
40˚C (104°F) and the POOL setting to
‘‘OFF’’
, so that when the automation system calls for
heat; it will activate the SPA mode and starts the pool heat pump.
Note:
When calling for a service technician, you will have to mention the installation of this
type of automation system.
Pool/Spa
W S
DS
AS
P/S
HP
LP
SPR2
FLO
COMP
AC
F1
F2
F3
PUM P
12
12
0
~ ~
Codes
For codes refer to the section titled “Service Analyser codes”.