I pg 12
Pool Heat Pump
To Start The Pool Heat Pump
Press the button on the electronic control ON/OFF to start the pool heat pump. The
temperature display will show the pool water temperature flowing in your pool heat pump
and the fan motor starts (fan blade turns) but the compressor does not start.
The temperature display flashes until the compressor starts and when the timer will complete
its cycle of 3 to 5 minutes. After 5 minutes, the compressor starts and the temperature on
the display stops flashing.
You can now program the desired temperature for the pool water.
To Stop The Pool Heat Pump
The pool heat pump can be stopped by pressing the
ON/OFF
button once.
To Check and Adjust Temperature Settings
To program the desired water temperature, press BOTH the UP and DOWN arrow keys at
the same time until the temperature degree displays change degree, then release them.
Press the UP arrow or DOWN arrow to program the desired temperature. The temperature
setting will automatically flash and will be saved. The display temperature will be revert
back to the pool water temperature when all keys have remained untouched for 5 seconds.
To change the temperature display from Fahrneheit (˚F) to Celcius (˚C). Press, the button
˚C/˚F. The led below the ˚F or ˚C will be lit to indicate the current selection.
Note: The pool heat pump will cut out at once when the programmed temperature has
been reached.