MANUAL REGENERATION
NOTE:
For softeners,
if brine tank does not
contain salt, fill with salt
and wait at least two hours
before regeneration. If you
need to initiate a manual regeneration,
either immediately, or the same night at
the preprogrammed time for regeneration
(typically 2:00 AM), complete the following
steps.
For Immediate Regeneration:
Press and hold
REGEN
until valve motor starts (typically 5 seconds).
For Regeneration the same night:
Press and release
REGEN
(notice that flashing “REGEN TODAY” appears).
ERROR
If the display toggles between “Error”
and an error code (i.e. a number),
call a service technician and report
the error code.
BYPASS VALVE OPERATION
To shut off water to the system, position arrow handles as shown in
the bypass operation diagram below. If your valve doesn’t look like
the diagram below, contact your service technician for instructions
on how to shut off water.
NORMAL OPERATION
BYPASS OPERATION
ADJUST HARDNESS, DAYS BETWEEN REGENERATION,
OR TIME OF REGENERATION
For initial set-up or to make adjustments,
please complete the steps as shown to
the right. Access this mode by pressing
NEXT
and
+
button simultaneously.
NOTE:
Hardness display shows “-nA-”
if used as a filter. If other displays do
not appear, refer to manual.
GENERAL OPERATION
When the system is
operating, one of three
displays will be shown:
time of day, gallons of
treated water available,
or gallons per minute.
Pressing
NEXT
will
toggle between the
three choices.
TO SET TIME
OF DAY
In the event of a
prolonged power
outage, time of day
flashes, indicating
that this needs to
be reset. All other
information will be
stored in memory
no matter how long
the power outage.
Please complete the
steps as shown to the
right. To access this
mode, press
CLOCK
.
1. Accessed by
pressing
CLOCK
2. Adjust hours with
+
and
—
buttons,
AM/PM toggles
at 12
3. Press
NEXT
4. Adjust minutes with
+
and
—
buttons
5. Press
NEXT
to
complete and return
to normal operation
1. Accessed by pressing
NEXT
and
+
button
simultaneously
2. Adjust hardness using
+
and
—
buttons
3. Press
NEXT
4. Adjust days between
regenerations using
+
and
—
buttons
5. Press
NEXT
6. Adjust time of
regeneration hour with
+
and
—
buttons,
AM/PM toggles at 12
7. Press
NEXT
8. Adjust time of
regeneration minutes
with
+
and
—
buttons
9. Adjust backlight setting
with
+
and
—
buttons
10. Press
NEXT
to
complete and return
to normal operation
© 2013 WaterCare All rights reserved.
LIT-WC CARE MAN ENVINK 10/13 250
QUICK REFERENCE GUIDE:
1900 Prospect Court • Appleton, WI 54914
Phone: 920-739-9401 • Fax: 920-739-9406
