Water Tec WT1, Руководство по эксплуатации

Страница: 40 / 43

RGB Test Switch.
The RGB test switch is designed to test the wiring without subjecting the driver or LED lamp to incorrect
wiring and therefore leading to blowing the driver or lamp.
The prosses of wiring is the same as you would wire up the drivers, this is done in series following the
wiring diagram.
The RGB test switch is used in place of the driver to check that all the colours are in sink Before you
power up the drivers.
Trouble shooting
If the lamps are not correctly wired, then you can have a range of options.
Turn on the Red switch and you see this
Check the Green and blue Common are not swapped
Turn on the Red switch and you see this
Any one colour not working
Check lamp the cable wiring to the colour which is not working
Turn on the Red switch and only the reds work
Check the Blue and green wire at the end of the chain are connected correctly.
The above is a sample of what may occur if the lamps have been incorrectly wire, to sum up if you see a
missing colour then check the colour cable which is not working. If all the connections are correct, then
test the lamp on its own with the switch to make sure the lamp is functioning correctly
LED lamp in series
Red Line in series
Red line in series
Green Line in series
Blue Line in series
R e d +
White - Red White -
Green + Green - Green + Green -
Blue + Blue - Blue +
Blue -