- 4 -
4
Example:
If your master code is “0000” and you wish to have a User PIN “1234”.
Master Code: 0000
New User PIN: 1234
Key
Description
‘#’
This activates the keypad.
“0000”
Enter the master code or the current user PIN.
‘#’
To enter “new PIN programming mode”.
“1234”
Enter the new PIN.
“1234”
Enter the new PIN again.
Long beep, backlight off
Confirms the new PIN has been usefully accepted.
Please Note:
After a new PIN has been programmed, the Master Code will still remain functional -
this is in case you ever forget your chosen PIN. Please store this manual which contains your
Master Code on the cover page in a safe place.
Learning in the Wireless Keypad
In order for the receiver to recognize the Wireless Keypad, the receiver must learn the keypad into
its memory. Learning the Keypad can be done in the same way when you learn a new remote
control for you receiver. For information on how to learn in a new remote control, please refer to
the Instruction Manual of your receiver. Instructions for programming a WKP into a Rhino
Watchguard Wireless Home Alarm are contained on this page as a ready reference.
Programming A WKP To Work With Your Watchguard Wireless Home Alarm System
TO ADD A WIRELESS KEYPAD FOLLOW THESE STEPS:
Step
Procedure
1.
Press 1 time
Disarm
the system (if it is not already disarmed) with an
original
remote control by pressing
Button 2
. You do not need to enter
programming mode.
2.
Press and hold
Button 2
(for approximately 3 seconds) on the
original
working remote control until the siren starts to beep
continuously, then release the button.
