Wassermann PRO DAR0355, Руководство пользователя

Страница: 24 / 28

DAR0355
24
5. PRODUCT DESCRIPTION
PURPOSE

The high pressure cleaner is designed to clean vehicles, machines, buildings, facades, etc. in the
private sector.
AREAS OF APPLICATION

Never use the machine in potentially explosive areas under any circumstances!

The operating temperature must be between 0 and +40°C.

The machine consists of an assembly with a pump, which is encased in a shock absorbing housing. For
an optimal working position the machine comes with a lance and a non-slip handle grip, whose shape
and configuration comply with the applicable regulations.

Do not cover or modify the lance or the spray nozzles in any way.

The high pressure cleaner is designed to be used with cold or lukewarm (max. 60°C); higher
temperatures can damage the pump.

Do not use water that is dirty, gritty or contains any chemical products, as these could impair operation
and shorten the life of the machine.

Accessories can be used to carry out work with foam cleaners, sand spraying.
6. ASSEMBLY

Position the washer as NEAR as possible to the water supply.

The washer must be used standing on a secure, stable and positioned as shown. FIG.3.

Fit the lance into the gun and rotating it until the two parts are completely locked FIG. 4.

Connect the gun to the high pressure hose FIG.5.

Connect the high pressure hose to the water outlet on the washer FIG.6.

Connect the water supply hose to female coupler FIG.7, then connect to the water inlet of the washer.
The supply hose must have an internal diameter of at least 13mm (1/2 in.) and must be reinforced. The
water supply must be at least equal to the washer delivery capacity.

NOTE: The machine not suitable for connection to the potable water main (FIG. 14).
WARNING
The intake water temperature must not exceed 40°C. The water supply must not exceed 7,0 bar (0.7 MPa).
CAUTION
The washer must only be used with clean water; use of unfiltered water of corrosive chemicals will
damage the washer.

Push the motor switch to
“OFF” position FIG. 9.

Check that the electrical supply voltage and frequency (Volt/Hz) correspond to those specified on the
washer rating plate. If the power supply if correct, you may now plug in the washer.
7. OPERATION

Turn on the water supply tap fully.

Release the safety lock FIG.8, then press the trigger for a few seconds to allow air to escape and
to discharge residual pressure in the hose.

Keeping the trigger pressed, push the switch to start the motor FIG.9.

When re-starting the motor, always keep the trigger pressed.
NOTE:
THE MOTOR ONLY RUNS WHEN THE TRIGGER IS OPERATED.