Disconnecting the Cable
DISCONNECTING THE CABLE
To remove the interface cable from the reader, first locate
the hole on the back of the handle. Next, take a paper clip
and modify it as shown in the figure below. Insert the
end
of the paper clip into the hole and press it to push on
the
clip that holds the connector. As you apply pressure,
pull
out the cable.
When reinserting the cable, make sure
the connector
clip is on the same side as the reader
release hole. Insert
the cable, it should click when it is
fully inserted.
USING THE
Wasp WDI9600
The
Wasp WDI9600
normally functions by capturing
and
decoding codes. The reader is equipped with an internal
Motionix™ motion-sensing function which activates
the
aiming system on device motion. The intelligent aiming
system indicates the field of view which should be
positioned over the bar code:
Aiming System
NOTE: We recommend the use of a perfectly
straight new staple to make the operation easier
(see the pictures below).
4
Wasp WDI9600
www.waspbarcode.com
