© CSP S.r.l.
27
Preparing to use the printer
5.2.2.
Tune menu
• Main menu: go back to main screen
• Speed: allows setting the speed during the print
• Flow: allows setting the flow during the print
5.2.3. Advanced menu (machine not printing)
“Advanced” section contains information relative to the management of the printer. To be used only in case
of real necessity.
• Main menu: go back to main screen
• Movement: Allows changing the settings relatives to movements and acelleration.
• Autoresurrection: enables the automatical Resurrection system
• Language: allows chosing beetwen English and Italian.
• Save in EPROM: saving settings in EPROM
• Load from EPROM: loads all the settings from the EPROM
• Default settings: Resets the system loading default settings
5.3. First start
After linking correctly the printer to the current it’s necessary to perform some operations so that the printer can
work.
Clamps on belts
Inside the printer there are three belts needed for moving the extruder during the print.
To avoid movements of the extruders during the transport, on the belts are set some clamps, to be removed
before the starting of the printer.
To perform the first print, proceed as described here:
•
Place the support of the tank aligned with the two holes on the top of the printer
•
Tighten the two screws in order to block the support
•
Turn on the printer with ON/OFF button on the back of the printer
•
Using the control handle select Menu>Prepare>Load material
•
Wait for the extruder to move in the middle of the printer
•
Grab the tank, with material loaded, and place it on the support
•
Connect the nylon pipe (8 mm diameter) in the right connector
•
Connect the PTFE pipe (12 mm diameter) in the right connector
•
Pressurize the tank by rotating the pressure control on the left side of the printer
•
Extrude the material with Menu>Extrude material
•
Zero the machine with Menu>Prepare>Autohome
•
Mesaure the distance between bed and nozzle with “Move axis”, then set it with Menu>Prepare>Modify
height (0.5 mm is the distance adviced between bed and nozzle)
•
Perform a manual leveling screwing or unscrewing the three regulation screws until reaching the necessary
planarity
•
Launch the print with Menu>SD Card> file.gcode
