Wasp Clay Kit, Начало работы, Страница: 6 / 12

CLAY KIT
PREPARING MATERIAL
LOADING MATERIAL:
1. Lay the mixture on a clean surface.
2. Add water (5% water 95% mixture) and mix until total absorption.
If the material feels too dry add some water.
3. Subdivide the mixture in balls to be loaded inside the internal of
the aluminum tank.
4. Untighten the handles on the cap of the aluminum tank (fig.1),
then remove the base with the 4 bars
(the side without valve)(fig.2).
5. Bring the nylon piston to the bottom to load the material.
6. Insert and compress the various parts of material (fig.3).
7. Place and tighter the base using the handles (fig.4).
ATTENTION:
Make sure before putting in pressure that the two caps are
perfectly touching and fitting on the tank in order to avoid air
losses and failures.
Make sure that the four handles are tighten well.
Lubricate periodically the threaded bars and the internal of the handles.
5
fig.3 fig.1 fig.2 fig.4
NOTE:
WASP provides a mixture to be fixed with water. The amount of
water depends on the kind of extruder, nozzle and environmental
conditions. Normally it is possible to use the following recipe:
porcelaine 95%, water 5%. With the provided machine it is
possible to print the majority of the mixtures.