washloo Clean, Руководство пользователя, Страница: 17 / 23

Installation Guide
1. Insert the electric plug into the designated socket/fused spur as
recommended by a qualified electrician.
2. When switched on – all lights on the unit will be illuminated. The Washloo
will now prime the water system for around 10 seconds and finally the
nozzle will extend out whilst performing a cleaning/first use test function.
3. After the first use test cycle – all lights will now turn off and a buzzer
sound will notify the user that the full cycle is now complete.
4. Now press the ‘Power On’ button on the toilet and/or remote control to
set the toilet to the ‘Standby’ setting.
5. Please note – Set the water temperature, water pressure and seat
temperature accordingly before use (We recommend you to set to a low
temperature/pressure for first use to avoid sensitivity until you are
familiar with the Washloo seat).
15
Note : The above illustration is an example only, your version may vary
Electrical Supply – Fused Spur Zones
1. For bathroom regulations, a fused spur can be installed by a qualified
electrician outside any Zone 2 as detailed below (known as Zone 3).
2. Removal of the sealed 3 pin plug and RCD is recommended when connecting
to a fused spur (this does not affect warranty).
Zone 3 is anywhere outside zones 0, 1 and 2 (subject to specific limits) and where
no water jet is likely to be used. No IP rating is required in these areas.
Preparation for water supply and test for operation.