WINCH MANUAL
MAINTENANCE
11
EN
Lifting
These winches are not recommended to be used for lifting, if you use your
winch for hoisting (lifting) then you need to implement a safety factor 5:1.
Ensure when using for lifting there is a minimum of 1 layer on the drum at
any time and pay attention to fixations and drum capacity.
Storage
The Hydraulic winch should be stored in the warehouse where the air is
dry and no corrosive gas. Do not put it under high temperature 50°C or at
a -20°C environment for long-term storage, in case the aging of sealing
parts are accelerated.
If the Hydraulic winch is in a long-term storage, the user should drain all
the oil from it, and fill the machine fully with Turbine Oil with a low acid
value.
LUBRICATION:
–
All moving parts within the Winch having been Lubricated using high
temperature lithium grease at the factory. No internal lubrication is
required.
–
Lubricate Cable Assembly periodically using a light penetrating oil.
CABLE ASSEMBLY REpLACEMENT
If the wire rope has become worn or is beginning to show signs of strands
breaking, it must be replaced before being used again.
1. Turning clutch to the “CLUTCH OUT” position.
2. Extend cable assembly to its full length. Note how the existing cable
is connected to the drum.
3. Remove old cable assembly and attach new one as the ld cable
connected to the drum. Insert the end of the new rope and secure
the screw being tightly screwed
4. Turning clutch to the “CLUTCH IN” position.
5. Retract cable assembly onto drum, first five wraps being careful
not to allow kinking, then winch cable must be wound onto the drum
under a load of at least 10% rated line pull.
WARNING
Only replace the wire rope with the identical replacement part
recommended by the manufacturer. Ropes are not part of any
warranty offered and the sole responsibility of the operate / user to
maintain or change.
