Warrior Winches 8000, Инструкции по сборке и эксплуатации

Страница: 5 / 19

5
most popular vehicle and mounting channels. If you cannot find a kit locally,
contact us and we will provide you with the name of a dealer near you. If you will
utilize the mounting channel you must ensure that it is mounted on a flat surface
so that the three major sections (motor, drum and gear housing) are properly
aligned. Proper alignment of the winch will allow even distribution of the full rated
load.
2. Start by connecting the Roller Fairlead (Part# 800700) to the Mounting Channel
(Part# 800025) using 2 each of the Cap Bolt M10 X 35 (Part# 800002), Flat Washer
(Part# 800004), Lock Washer (Part# 800003) and securing with M10 Nut(Part#
800024) (Make sure the bolt is placed through the mounting channel and roller
fairlead from inside the channel. This will allow enough clearance for the winch to
be placed in the channel without obstruction.)
3. Assemble the winch to the Mounting Channel (Part# 800025) by first pulling and
releasing the clutch knob to “Off” position (Free Spooling). Pull out a few inches
of cable from the drum and feed the wire loop through the opening in the front of
the mounting channel and roller fairlead. Now, using the remaining M10 x 35 Cap
Bolts (Part# 800002), Flat Washer (Part# 800004), Lock Washer (Part# 800003)
and M10 Nut (Part# 800005) secure the winch to the mounting channel.
4. Connect the battery and motor leads as the drawing above every type of winch is
different each other.
CAUTION
–
Batteries contain gases which are flammable and explosive.
Wear eye protection during installation and remove all jewelry. Do not lean over
battery while making connections.
5. Assemble the Clevis Hook to the cable. Take off the pin from the Clevis Hook,
connect the Clevis Hook to the cable and mount the pin back to the Clevis Hook.
6. Always use the Hand Saver when free-spooling and re-spooling the wire rope.
Using the Hand Saver keeps your hands and fingers away from the rotating drum.
7.
Check for proper drum rotation. Pull and turn the clutch knob to the “off” position
(Free-spooling). Pull out some cable from the drum, and then turn the clutch knob
to the “In” position to engage the gears. Press the cable out button on the power
switch. If the drum is turning and releasing more cable then your connections are