Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
FJ Cruiser Front Bumper
INSTALLATION INSTRUCTIONS
WAR 3520/3530
The Warrior Products 3520 & 3530 FJ Cruiser bumpers are designed to fit the XRC 8K thru 12K
series of winches and although the bumper has a fairly roomy interior for winch fitment, Warrior
Products makes no guarantees to the compatibility of other winch brands. When fitting the bumper it
is a good idea to have a helper available as the bumper can be a bit cumbersome and heavy for one
individual to handle alone, particularly when pre-fitted with a winch.
1.
Begin the installation by removing the OEM grill, front bumper cover and all associated trim
pieces outlined below.
a.
Temporarily remove the headlight surround/grill by accessing the push-pins and screws
along the top side and some clips along the bottom inside. Lift it out of the way and set it
aside.
b.
Remove the stock plastic bumper cover by accessing the push-pins along the topside and
the lower bumper retaining screws and a couple screws located in the forward edge of
each wheel well.
c.
The ends of the plastic cover can now be flexed out and then the entire cover moved
away and down off of the bumper reinforcement bracket.
d.
Remove the inner bumper reinforcement bracket with extensions and retain the nuts for
installation of the Warrior bumper.
e.
Remove the front bumper upper retainer.
f.
Remove the molded plastic front bumper side supports; one on either side.
g.
The inner fender well liners will have a ‘bowled’ section hanging down. Trim this
section off at the fender well ceiling.
h.
The front fenders will now need to be reattached to the body. Snap the square nylon nut
into the square hole visible after removing the molded plastic front bumper side supports
and use the provided _” x _” bolt with _” flat washer to fasten the front fender mounting
tab back onto the body.
2.
The vehicle should now be ready for installation of the bumper.
