Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
3.
Using an assistant, lift the bumper up and onto the 8 frame-cap mounting studs. The oblong
holes are slightly oversized to allow proper visual alignment as the frame and body will not
always be exactly parallel to each other. Be aware of the notch in the winch plate for clearance
of the condenser line. If the line is in contact with the bumper or frame it will need to be
reshaped slightly. (see instructions below)
a.
To minimize the strain on the lower fitting while reshaping the tubing, temporarily use a
small spacer such as a piece of wood or plastic that fits between the condenser line and
the radiator support just above the lower fitting. Gently flex the line until it is within a _”
of the horizontal core support located approx 6” inches above the fitting and centered
within the notch on the winch plate.
4.
Thread the nuts onto the studs, but only hand-tighten at this time.
5.
Place the winch plate frame brackets on top of the frame just inboard of the body lift spacers.
Insert the 3/8” bolts through the brackets and into the corresponding oblong holes in the winch
plate of the bumper. Place the split washers on the bolts and thread the nuts up from underneath
the bumper. Do not tighten at this time.
