WARPP INMIG 250 IH, Руководство по эксплуатации

Страница: 7 / 20

1. input wire connection
There is a power wire for each machine.
180/200’s power wire should be connecting to AC 220V; 250’s power wire should be
connecting to AC 220V, there is no phase order for three wires
.
2. output wire connection
Please connect the gas cylinder which is with the gas gauge to the CO2 enter door at
the rear of machine through gas tube.
Please connect the quick connector of grounding wire to the corresponding quick joint
of the machine; other end of grounding wire should be connecting to the working
piece.
Please connect torch to the joint of wire feeder and fasten it, and put the welding wire
into torch.
3. roller assemble
Please put the roller which is with welding wire on the axle of wire feeder; please
make sure the roller is put right and stable.
Please choose the right roll for the welding wire.
Release the the roll pinch, put the wire in groove, adjust the roll pinch to press the wire,
in order to keep the wire stable in groove, but the pressure could not be big for wire
feeding.
Roll should be running with clockwise to release the wire.
Please choose the dimension of roll basing on the dimension of wire for welding
Please touch the button to feed the wire out of torch