Warnock Hersey Patio Plus, Инструкции по установке, эксплуатации и обслуживанию

Страница: 9 / 15

9
ASSEMBLY INSTRUCTIONS
PH-45-FB-LP (Liquid Propane), PH-50-FB-N (Natural Gas), PH-45-FB-R-LP
(Liquid Propane & PH-50-FB-R-N (natural gas).
Fixed base model for permanent mounting to deck or patio. (“R” indicates heater
with remote switching option. Requires
switched 24 Volt power supply to heater.)
Step 1
Determine a safe, level and stable location for the
base mount to be installed.
Step 2
Secure the base to the deck or concrete pad with
appropriate fasteners. Use all three mounting
holes. Use corrosion resistant hardware. Inspect
condition of mounting studs before use of the
heater each season. Replace if rusty, loose, or
shows signs of damage. Use of through bolts is
recommended on wood decks.
Step3
Remove the 3/8” x 1” bolt in the base of the
heater head and set aside. (Figure 2 previous
page 7). Secure heater head to flexible hose
protruding from the top of the post. Use two pipe
wrenches to securely tighten. A suitably
approved gas pipe sealant must be used for all
gas connections. Slide head assembly into post.
Aline the 3/8” hole in the post with the 3/8”
threaded hole in the base of the heater head, and
replace the 3/8” x 1” bolt. Secure tightly.
Step 4
Slide the decorative cover onto the post from the
bottom. Place the post into the basemount “T” and slide the decorative cover down over
the post retainer. Connect gas supply to the nipple protruding from the lower side of the
tube.
Step 5
Secure the reflector to the heater head with the hardware provided.
CAUTION: Gas supply and electrical supply are to be according to all local and
applicable codes. Only those individuals licensed and qualified in the installation of gas
fired heating appliances are to install this appliance.
If your heater is supplied with the remote switching option, connect your switched 24 V
power supply to the spade connectors protruding from the bottom end of the post.
Connect spade connectors at the top of the post to the marked connections on the heater
head. All supply wiring must be done in accordance will national, local and applicable
codes. Only those qualified and experienced in such wiring should be engaged for the
installation of the electrical supply.
Deck or
concrete
pad
Gas shutoff
by others
Underground
gas supply