Auger Bearings and Auger Shafts
The auger bearings (PART #PU-UCF204-12) are a sealed unit and do not require
lubrication. To replace the top auger all the fuel must be removed from the hopper, as well as
the top auger motor assembly (see above). Once this is done the four bolts that hold in the
bearings can be removed. At this time, the complete auger assembly can be
pulled from the stove. Loosen the two (2) set screws with a 9/64” allen wrench, which will
disconnect the bearing from the shaft. The bearing and auger shaft can be replaced by
reversing this procedure. When placing the auger bearing and shaft assembly back into the
unit, always tighten the four bolts in a diagonal pattern to assure the bearings are aligned
properly. Follow the same procedure to work on the bottom auger, with the exception that the
pellets do not have to be removed from the hopper.
Convection Blower
The convection blower (room air blower) — PART #BM-1376 — is located under the burn
pot of the unit and can be removed by disconnecting the power leads and removing the four
screws. Once this is done, the blower should slide out the rear of the unit. Reverse this
procedure to install a new room air blower.
Combustion Blower
To clean or replace the combustion (exhaust) blower — PART #PU-076002 — the power
leads and the pellet vent pipe must be disconnected. Next, remove the four screws that hold
the blower to the steel exhaust tube and the entire blower should release from the stove. The
blower impeller, blower tube and the steel blower exhaust tube on the stove should be
brushed and vacuumed. When cleaning or replacing the blower a new gasket should be
added between the blower flange and the steel exhaust tube.
Gaskets
This unit comes with a 3/4” rope gasket around the door, which should be replaced every
two years. To replace the door gasket (Part #AC-DGKC), the old gasket must first be
removed entirely — this may require you to scrape the old material from the channel before
adding the new cement. Once this has been done the door should be closed and latched for
twenty-four hours to allow the adhesive to harden. If you are replacing the window gasket
(PART #AC-GGK), the new gasket already has adhesive on it. Remove the paper on the
adhesive side and place the gasket around the outside edge of the glass, by forming a “U”
with your fingers and running the new material around the window. The door and window
gasket can be ordered from your local dealer or from the factory.
Finish
This new unit has been painted with 1200 degree Metallic Paint (PART #AC-MCSP) that
will retain its original look for years. If the unit should get wet and rust spots appear, they can
be sanded with plain steel wool and repainted. We recommend this paint, as others may not
adhere to the surface or withstand the high temperatures.
Glass
This unit has a 9” x 9” ceramic glass (Part #AC-G9) in the viewing door. If this glass
becomes cracked in any area, the unit should be shut down and the window replaced. The
glass can be ordered from your dealer or from the factory.
You may order parts and options on our web site:
www.englandsstoveworks.com
,
or by calling (800) 516-3636.
Our web site also offers service instructions that can be printed or viewed as video.
Содержание 25-PAF
Страница 16: ...Pellet Stove Exploded View...
Страница 18: ......
