IMPORTANT INFORMATION
1. Check local installation codes for your area.
2. Read and comply with the instructions in this manual.
3. This unit should be tested (dry run) before loading pellets.
4. Your stove is designed to burn Premium Hardwood Pellets. Pellets with a high ash
content will burn dirty and the unit will need cleaning more frequently.
5. Be sure your pellets are not damp or wet. Keep sawdust out of the unit.
6. Use 3” PELLET VENT PIPE with this stove and follow the manufacturer’s specifications
for installation and clearances. Even though this pipe interlocks it is a good idea to seal
all connections with high temperature silicone.
7. An outside combustion air connection is mandatory for this unit to work properly. Make this
connection using a 1
7
/
8
” I.D. metal pipe (steel, aluminum or copper) and coupler. Be sure to
secure the pipe to the unit with aluminum tape or a clamp. Our part number PU-OAK
(Outside Air Kit) can be used. The outside end should be covered (screened) to prevent any
foreign matter from getting into the system.
8. Regularly inspect the ash build-up in the burn pot and, if any crust forms remove it from
the burn pot with a poker.
9. The ash in the burn pot should be removed regularly, depending on your burn rate. The area
to the right and left of the burn pot is for ash storage; keep the air holes in the burn pot clean
for a more efficient burn. You should also frequently check the exhaust system.
10. Keep pellets and all other combustible materials a safe distance from the stove.
11. This unit will require floor protection if it is installed on a combustible surface.
The minimum floor protector for this stove is 36” x 36” which should give you at least one
inch (1”) of protection at the rear, four inches (4”) on each side and six inches (6”)
minimum in the front of the unit.
12. Horizontal runs should not exceed four feet (4’) with a maximum vertical flue
height of thirty five feet (35’). At a height of fifteen feet (15’) the pipe should be
increased to 4” PELLET VENT PIPE.
13. This unit should be turned off and allowed to cool prior to cleaning. Any ashes should be
kept in an airtight metal container completely away from all combustibles and should not
be disposed of until they are completely cooled.
14. Read the instructions thoroughly concerning the various settings that are available
with the digital read-out control board.
Visit our web site at
www.englandsstoveworks.com
for helpful information,
frequently asked questions, parts & accessory orders and more.
UNIT PREPARATION
Do not allow paint, chemicals or construction dust on or near your unit. Do not allow liquid or ANY
foreign materials on or inside your unit. Shut your unit down and cover it when painting, construction or
similar activity is taking place. Wipe and clean your unit after any construction is done in your home, or if
any foreign material gets on or inside your unit. You may also need to remove the rear and side cover plates
to your unit (unplug unit first) and vacuum and clean the motors and inside of your unit.
Содержание 25-PAF
Страница 16: ...Pellet Stove Exploded View...
Страница 18: ......
