Warner Electric X2DRV, Руководство по установке и эксплуатации

Страница: 2 / 5

Tension control system X2DRV
29/08/2012
X2DRV Installation & Operation Manual Page 2 of 5
Ratings:
Main Supply Voltage (V)
24V DC +/- 5%
Output 4A with Anti Residual
Operating T°C -10°C to 50°C no Condensation
Compliance
General information:
Control chassis should be kept clear of all areas where foreign material, dust, grease, or all might affect the operation of the control.
Installation must be made in accordance with the instructions found in this manual. Failure to do so may damage the Driver.
This driver supports the following Warner brakes : TB’s, ATT’s, MPB’s, MPC’s. POB’s, POC’s and MTB’s brakes cannot be driven by this device.
Installation instructions:
Hardware Pin Out:
1 BK1+ Power Output
Brake 1
Integrated Anti-residual control. Voltage or Current controlled.
2 BK1- Power Output
Brake 1 Output –
3 BK2+ Power Output
Brake 2
Integrated Anti-residual control. Voltage or Current controlled.
4 BK2- Power Output
Brake 2 Output –
5 ON1 Analog input
Full power : 24VDC applied to brake 1
Active low / GND: NPN type Input
6 OFF1 Analog input
Power Off brake 1 : 0V applied to brake 1 with anti-residual
Active low /GND: NPN type Input
7 Gnd Ground
8 ON2 Analog input
Full power : 24VDC applied to brake 2
Active low /GND: NPN type Input
9 OFF2 Analog input
Power Off brake 2 : 0V applied to brake 2 with anti-residual
Active low /GND: NPN type Input
10 Gnd Ground
11 InBK1 Analog input
Brake 1 Input signal control.
Selectable: 0/+10V DC or 4/20mA.
12 Gnd Ground
13 Ana1 Analog input
Brake 1 Auxiliary input : To compensate Brake1 signal in Open Loop control
Selectable: 0/+10V DC or 4/20mA.
Teachable Span (item 9 page 4).
14 Gnd Ground
15 10V Power out
External interface Power Supply. 10VDC, 100mA Output
Used to Power an external potentiometer to get an Open Loop control (local torque
adjust)
16 Gnd Ground
17 InBK2 Analog input
Brake 2 Input signal control.
Selectable: 0/+10V DC or 4/20mA.
18 Gnd Ground
19 Ana2 Analog input
Brake 2 Auxiliary input : To compensate Brake2 signal in Open Loop control
Selectable: 0/+10V DC or 4/20mA.
Teachable Span (item 9 page 4).
20 Gnd Ground
21 10V Power out
External interface Power Supply. 10VDC, 100mA.
Used to Power an external potentiometer to get an Open Loop control (local torque
adjust)
22 Gnd Ground
23 24V Power supply 24VDC Power supply Input
24 GND Ground GROUND