WARN INDUSTRIES
PAGE 5
61285 Rev C0
8.
Pry away or cut away the lower corners of the wire mesh, as shown in Figure 6 below.
This is done so that the upper receiver bracket and U-bolts can be installed.
FIGURE 6
9.
As shown in Figure 7, attach the front receiver bracket assembly to the front of the
brush guard and to lower support bracket, using two 5/16”-18 x 1” bolts and two U-bolts,
lock washer and nuts. Tighten all the 5/16” and M8 nuts to an approximate torque of 21 ft-
lbs.
FIGURE 7
