©2015 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
7
95470B0
I N S T A L L A T I O N I N S T R U C T I O N S
17. Insert spacer (A15) into the vehicle frame (behind front
flange). Figure 12.
18. Repeat for other side.
19. Hold left hand bottom frame bracket (A6) in place, using
washer (B3) on bolt (B2).
Bracket will hang in place until fully
secure.
Do not tighten at this time.
Figure 13.
20. Repeat for other side.
21. Align left hand inner bracket (A12) with bolt from previous
step.
22. Secure in place (
hand tighten only
) with lock washer (B4) and
nut (B5). Figure 14.
23. Do not tighten at this time.
24. Using three bolts and washers (B1& B7), attach the left hand
bottom frame bracket(A6). Insert the first two bolts (B1) with
washers (B7) through bracket and vehicle frame. Fasten with
washer (B7), lock washer (B8) and nut (B9).
25. Insert the last (
most rear
) bolt (B1) with lock washer (B8) and
washer (B7). Fasten with nut assembly (A14).
26. Check position of bracket, making sure it is as close to the
back of the vehicle’s bumper mounting flange as possible.
Once in place, tighten bottom hardware at this time.
27. Clip OR bend excess nut assembly wire handle, making even
with end of frame.
Figure 14
Figure 15
A15
Figure 12
Figure 13
A12
A6
B3, B2
Nut assembly
A14
B7, B8 and B9
