WARN INDUSTRIES
PAGE 5
80551A2
©2009 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
INSTALLATION CONT.
4. Place the plow mount over the bottom frame
tube. Ensure the plastic belly skid plate is be-
tween the mount and the frame.
Install the two M10x 1.25 bolts through the cen-
tral holes and into the bottom frame tube.
Do
not tighten, this is for positioning only.
See
Figure 4.
5. Place two 5/16” x 1 3/8”
U-bolts around the two
upright tubes and through the slotted holes in the
back of the face of the plow mount. Secure with
(4) 5/16” Flat washers and (4) 5/16” Nylock Nuts.
Tighten the U-Bolt nuts just enough to take the
slack out of the bolts but do not tighten. As you
will need to slide the mount upward into position
for the next step. See Figure 5.
6. Drill two holes into the plastic belly skid plate
where the inner/lower slotted holes are located
on the bottom tab of the plow mount. Place
two 5/16” x 1 1/2” U-bolts around the two bottom
frame tubes and through the slotted holes on the
bottom tab of the plow mount. Secure with (4)
5/16” Flat Washers and (4) 5/16” Nylock Nuts.
Do not tighten. (Figure 5)
7. Making sure the mount in centered on the ve-
hicle, tighten the two upper U-Bolts. Tighten
each nut to the torque specified in the Table at
the beginning of this document. Back the previ-
ous installed M10 bolts out about half way. Make
sure that the LH and RH locating brackets still
slide after you tightened the upper u-bolts in the
previous step.
8. Tighten the two lower U-Bolts. Tighten each nut
to the torque specified in the table at the begin-
ning of this document.
9. Remove the two M10 X 1.25 bolts from the cen-
tral holes.
10. Install the front bumper. First, install the top
two bolts and loosely secure. Then bring the
smashed bottom ends in between the inner locat-
ing tabs of the plow mount. Thread the (2) M10
X 1.25 bolts through the tab, spacers, flattened
bumper tube end, and into the bottom frame
tube. Tighten to the torque specified in the table
at the beginning of this document. Tighten the
1/4-2 hex head bolt that attach the inner locating
tabs at this time. See Figure 6.
Figure 5
Step 4
Step 5
Figure 4
Figure 6
