WARN INDUSTRIES
PAGE 5
70736A3
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
INSTALLATION CONT.
9.
If using a winch to operate the plow, install the J-Bolt
bracket (62845) to the cross-member of the plow.
Note: If using a winch to operate your plow, proceed to
step 10. If using an electric actuator, or manual lift to
operate your plow, please refer to the instructions that
came with the manual lift kit.
10.
Run the winch cable through the roller fairlead and
down to the plow. Attach through the end of the
winch cable around the end of the J-Bolt. Slide the
threaded end of the J-Bolt (C) through the round holes
in the bracket. The open end of the J-Bolt will fit into
one of the slotted holes.
Note: If you have a hook on the end of your winch
cable, simply move the hook out of the way when
attaching the cable to the J-Bolt.
11.
Attach the 1/4” nut and washer to the end of the J-
Bolt. The J-Bolt should be tightened until the open
end drops down into the slot. Do not over tighten the
J-Bolt as this may pinch and damage the cable. The
completed assembly will look as shown in Figure 8.
Figure 7
Figure 8
Figure 9
8.
If you haven’t already done so, assemble the plow per
the instructions included in the plow kit. Attach the
plow to the mount using the pins provided in the plow
kit.
Plow installation with a winch is now com-
plete. The assembled product should look like
Figure 9. Skip the rest of this section and
move to the next section titled “Maintenance/
Care”.
