WARN INDUSTRIES
PAGE 3
61584 Rev C0
Step Three:
Install the front plate to the ATV as shown. Start by loosely fastening the two 1” U-bolts, then
fasten the two 8mm bolts supplied in the kit to the bike frame as shown.
8mm
bolts
1” U-bolt fasten with ¼’-20
nuts, washers, and lock
washers
Step Four:
Tighten all fasteners. Replace the plastic front cover to the ATV frame.
REAR-RECEIVER INSTALLATION:
Step One:
To remove the trunk unscrew the two Phillips head screws at each side of the trunk. Then
disconnect the electrical connections which connect the circuitry to the top of the trunk. The two 8mm bolts
which connect the rear rack to the ATV frame must also be removed.
Phillips head screw
(one on each side)
Electrical
Connections
8mm bolts
(two on each
side)
