©2019 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
4
105724A0
I N S T A L L A T I O N I N S T R U C T I O N S
1. Remove the bumper by removing the two torx head screws,
two upper bolts and one lower from each side of vehicle.
Retain hardware.
2. Slide bumper forward while carefully leveraging the plastic
out of the way.
3. Line up the new bumper mount (A3) with the stock bumper
mounting location.
4. Install one M8 bolts (B1) with washer (B2) through the top
two mounting holes (each side).
5. Insert one M8 bolt (B1) through bottom mounting hole
(each side)
.
NOTE: This is to help hold mount up in place
and will be removed in a later step.
6. Secure upper bolts with one washer (B2) and lock nut
(B3)
(each side)
.
NOTE: Tighten only the upper two bolts,
washers and locknuts at this time.
5. Cut the plastic along the white line shown in the photo
(each side)
.
6. Install one factory torx head screw through plastic, upper
mounting bracket and frame
(each side)
.
7. Remove the lower mounting bolt
(each side)
.
Torx head
screws
Remove
Remove
Cut plastic
B1, B2 and
B3
B1
Figure 2
Figure 3
Figure 4
Torx head
screw
Lower mounting
bolt
