©2018 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
7
100837A0
I N S T A L L A T I O N I N S T R U C T I O N S
16. Align left hand inner bracket (A10) with bolt from previous
step.
17. Secure in place (
hand tighten only
) with lock washer (B4) and
nut (B5). Figure 12.
18. Do not tighten at this time.
19. Using three bolts and washers (B1& B7), attach the left hand
bottom frame bracket(A6). Insert the first two bolts (B1) with
washers (B7) through bracket and vehicle frame. Fasten with
washer (B7), lock washer (B8) and nut (B9).
20. Insert the last (
most rear
) bolt (B1) with lock washer (B8) and
washer (B7). Fasten with nut assembly (A12).
21. Check position of bracket, making sure it is as close to the
back of the vehicle’s bumper mounting flange as possible.
Once in place, tighten bottom hardware at this time.
22. Clip excess nut assembly wire handle off, making even with
end of frame.
23. Tighten 5/8” bolt (B2) installed in step 15.
24. Remove clamp and tighten all hardware at this time.
25. Repeat steps 16-24 for other side.
NOTE: You may wish to remove the two side impact bars
at this time, because after bumper installment is
complete, the impact bars will be exposed. See Figure
18.
Figure 14
Figure 12
Figure 13
A10
A12
B7, B8 and B9
Side impact bars
