Installation Instructions
SECTION
2
5
2. PERFORM A TEST INSTALLATION OF THE HEATER BEFORE STARTING
A. After the surface is prepared, conduct a preliminary fit by leaving the white release liner on the heater and holding the
heater under the counter to ensure it fits as expected and that there are no conflicts with supports, doors, or other items.
• The front edge of the heater should be mounted between ¼” and ½” from the countertop edge. Precision is
not critical.
• If the connection wire or power supply will be connected to an outlet inside a cabinet, use a pencil to mark
where the connection wire will enter the cabinet.
B. After preliminary test fitting, lay the heater on top of the counter WITH THE WHITE RELEASE LINER FACING UP.
NOTE: Once the release liner is removed, the adhesive is very sticky and can be difficult to remove if it
bonds to the stone.
Approx. 72”
Thermal Control Unit
Approx. 60”
Approx. 42”
Approx. 24”
Heating Element
Transformer
To 120V House Outlet
