Read these instructions completely before starting assembly and installation.
1. EVALUATE AND PREPARE THE SURFACE OF THE COUNTERTOP
A. Evaluate the lower surface of the countertop to determine if the Surface Prep Kit must be used to create a smooth,
uniform surface, which will ensure a secure bond for the heater. Use the peel test strip included in this package to
evaluate whether the surface of the stone needs the Surface Prep Coating. If the counter is “rough cut” natural stone,
the WarmlyYours FeelsWarm® Surface Prep Coating will be necessary. As a general rule, a Surface Prep Kit will be
needed if the heating mat is being applied to quartz, “rough” feeling granite underneath the counter, or supporting
wood. Smooth granite and any stone with a mesh backing will most likely not need a kit.
B. To determine whether or not the stone surface will be acceptable as is (without the Surface Prep Coating), attach the
peel test strip to the underside of the counter and press with fairly hard pressure. Let the strip remain on the stone for an
hour, then peel the strip off by hand. If the strip bonds extremely well, then applying the Surface Prep Coating is
not necessary.
C. If it is determined that the coating is needed, apply the Surface Prep Coating onto the area where the heater is to
be attached. Follow the instructions below, labeled “Surface Prep Instructions”. The coating must cure completely—
approximately 30 min. The surface will no longer be tacky when it has dried fully.
D. If no Surface Prep Coating is used, clean the surface where the heater will be attached. Clean with a rag and isopropyl
alcohol. This will remove dirt, dust, and other debris. Let dry completely (approximately 5 minutes).
E. If your heater is larger than 4 square feet or is an unusual shape or configuration, you will need another person to help
attach the heater to the countertop.
Surface Prep Instructions (If needed)
Kit Contents:
• 2 containers of epoxy (Part A and Part B)
• Small brush
• Mixing tin
• Tongue depressor
Recommended Tools and Supplies:
• Protective eyewear REQUIRED
• Gloves and appropriate clothing
• Pencil
• Drop cloth or other material to protect carpet or flooring under the countertop
If the surface is not suitable for bonding, then WarmlyYours FeelsWarm®Surface Prep Coating will need to be applied to
the surface prior to installing the heater.
Installation Instructions
SECTION
2
3
