29 March 2021
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm
………….
Copyright ©
4
SELECTI0N OF THE SIZE OF FIRE TO FIT THE EXISTING CHIMNEY
The size of the fire and the flue diameter needs to be balanced for the fire to operate correctly.
The size of the Warmington firebox that is to be fitted to an existing masonry fire place, is generally set by the
opening of the masonry flue system x and y (see table below).
Remedial work may need to be carried out to physically fit the firebox into the masonry opening, however this
may limit the size of the fire that can be fitted.
Firebox
SG/EG
700
SG/EG
780
SG/EG
900
SG/EG
1100
SG/EG
600
Flue
K
200
200
250
250
150
Flue Liner
L
250
250
300
300
200
FIREBOX SELECTION
Remedial work may be necessary to fit the firebox into the masonry
cavity, BUT the flue diameter
‘
K
’
will determine the size of the firebox.
The selected Firebox flue
-
(diameter
“
K
”)
MUST be able to pass through
the masonry chimney whether the flue pipe is being used, or the existing
chimney is being used.
Always consult your Technical Representative for advice.
FLUE HEIGHT MINIMUM DETAILS
The flue penetration is to comply to relevant
standards.
3D View
Note:
Firebox can also be custom built to suit
(modification cost will be incurred).
Existing chimney opening size must be larger than
the required flue and liner size (see above table
for K and L measurements.
The height of the masonry flue may need to be
increased to obtain correction operation of the fire.
