8
!
2.Assembling the fan
BB
CC
P
D
BB
B
C
E
1
2
3
4
F
Assembly
1.Install the suspension system components
1. Insert the ball/downrod (B) through the canopy(C) and canopy bottom cover (D), and then
slide the decorative motor collar cover (E) onto the end of the ball/downrod(B). Make sure
the slots on the canopy (C) are on top.
DD
WARNING: Failure to properly install the
locking pin could result in the fan becoming
loose and possibly falling.
1.Route the wires exiting the top of the fan motor
assembly (F)through the downrod as shown.
2.Loosen,but do not remove, the setscrew on
the collar (P)on top of the motor housing.
3.Align the holes at the bottom of the downrod
(B)with the holes in the collar (P)on top
of the motor housing.
4
.
Carefully insert the hanger pin((CC)through
the holes in the collar (P)and downrod(B).
Be careful not to jam the hanger pin(CC)
against the wiring inside the downrod (B).
5
.
Insert the locking pin (DD)through the hole
near the end of the hanger pin (CC)until it
snaps into its locked position.
6
.
Re-tighten the setscrews on the collar (P)on
Re-tighten the setscrews on the collar (P)on
