12
Assembly— Hanging the Fan (continued)
8.Attaching the light kit fitter assembly and the bulbs
!
WARNING: to reduce the risk of electric shock, please
operate after starting to disconnect the power supply of
circuit breakeror fuse box.
!
WARNING
: E12 The two bulb
MAX60W*2PCS.
1.Install the two E12 bulbs by screwing them into the light bulb sockets.
2.Remove the metal tapping washer (N) and the finial (O) from the light kit fitter assembly (G).
3.Slide the acrylic plate (J) upwards. While holding the acrylic plate (J), Place the metal tapping washer (N)
over the center rod and secure the finial (O).
4.Remove the three screws on the switch cup cover of the light kit fitter assembly (G).
5.Connect the wires from the light kit fitter assembly (G) to the wires from switch cup of the fan motor
assembly by connecting the molded adaptor plugs together (blue to blue, white to white).
Carefully tuck all wires and splices into the switch cup.
6.Align the holes in the light kit fitter assembly with the holes in the switch cup below the fan motor
assembly and install the light kit mounting screws that were removed in the fourth step above.
7.Align the top cover (C) with the hole knob of the mounting bracket (A)and tighten with two screws.
Make sure that canopy covering the outlet box. Slide the lower cover (D)upwards until the lower
cover (D) is firmly sucked.
C
D
J
N
O
G
