WANHAO CGR Series, Руководство пользователя

Страница: 11 / 29

9
This 3D printer is connected to an electrical network with an input of 110 or 240 VAC,
50/60Hz, and has an operating voltage of 24V.
- Insert the power cable cord into the socket at the back of the printer.
- Do not allow anything to rest on the power cord.
- Do not place the printer and cable where people will walk on or trip over the cord.
- If an extension cord is used with the printer, make sure the combined ampere
of all equipment plugged into the extension cord does not exceed the extension’s limit.
- Do not overload a power outlet, strip, or receptacle by plugging in too many devices.
- Remove the power cable cord when printer will not be used for long periods of time.
- Before unplugging the power cord, remember to turn off the printer.
- Use the printer only with the cord supplied in the original packaged set. For power
cord replacements, ensure the following requirements are met: detachable type,
UL listed/ CSA certified, VDE approved or its equivalent, 4.5 meters (15 meet)
maximum length.
- In case of malfunction, unplug and disconnect the printer immediately from
the network.
- Do not attempt to fix the product without seeking qualified technical service
personnel, or you may risk being exposed to dangerous voltage points after
removing covers.
- For technical service please contact your location distributor, or contact
WANHAO at support3@wanhao3dprinter.com.
Disposal Instructions
Do not dispose of this printer as regular waste. Please minimize pollution to the environment
and recycle or return to WANHAO for recycling.
C
Repair Recommendations
Unplug the printer form the wall outlet and contact a qualified service personnel when:
- The power cord is damaged, cut, or frayed.
- Liquid is spilled into the printer.
- Printer is dropped or case is damaged.
- Product exhibits distinct changes in performance that indicates malfunction.
- Product does not operate normally after following operating instructions.
AFTER SALES SUPPORT
86-571-63379578 support@wanhao3dprinter.com
ELECTRICAL POWER