WangYe WY50QT-28A, Руководство пользователя

Страница: 14 / 20

- 23 -
If the motorcycle have not been used for a
long time. Taking off the battery and putting
it into a dry and place
The head of battery was corroded, please take
it off and clean. (Can use boil water)
NOTICE: turn off the ignition switch, take apart negative pole
○
- first, but install positive
pole
○
+ when you are installing
.
Adjusting idling speed (Fig 24, Fig 25)
warm up few minutes before start
Idle to adjust screw (1) is it is it improve idle
speed slightly to enter to fasten, is it is it
withdraw it than screw slowly after stocking
to fasten to mix and then rapidly, to
stabilizing the position at most, then
withdraw slowly, get and stabilize the
position the most low.
After adjust idle, then adjust accelerate graph handle to free
path for 2-4mm,then use adjustor (2) to adjust, screw down nuts,
and then screw up it after adjust.
Adjusting the good idle speed, when should be able to suddenly
strengthen the throttle, the rotational speed of the engine should be
Fig24
Fig25
- 24 -
excessively steady, no flash back and can't go out, stop working or
arrange organ not to blow out at being last throttle.
Replacing gearbox oil (fig 26)
Suggestion the engine oil number
SAE 80W/90
（
the vehicle in north could use the antifreeze liquid
）
Oil container
Resolving capacity:0. 10 L
Changing capacity:0. 09 L
•
Steady the motorcycle
•
Take apart the limiting bolt (1), and the spilling bolt (2).
NOTICE: THE ENGINE MUST BE WARMER
WHEN SPILLING, AND THE VEHCILE MUST
BE STEADYING BY MAIN STAND!
Reinstall the spilling bolt after clean. And screw up.
Inject 100ml to engine through immix bolt
Install immit bolt and screw up.
•
Fig. 26