W&H Osmo, Инструкция по эксплуатации

Страница: 6 / 36

Note
:
if the Osmo demineralizer is used to supply sterilizers with demineralized water, it is imperative to monitor the water quality. If the supplied
sterilizers do not feature a water conductivity sensor to monitor the water quality, we recommend using the manual water conductivity
meter
Primo 5.
Electrical connection
Before plugging in the unit to the power socket, check that the voltage shown on the rating plate, corresponds to the one of your work
place.
Earthing of the equipment is compulsory by law. Any deliberate cutting of the earth wire inside or outside the unit or removal of
the earth terminal from the plug is forbidden in that the unit becomes hazardous.
The manufacturer declines all responsibility in respect to persons or things arising from failure to observe this rule. The electrical safety of
this unit is only guaranteed when it is correctly connected to an effective earthing system, as provided by current electrical safety laws.
If you do not have an electrical system with proper earthing, do not connect the unit to the socket and consult a specialist electrician as
soon as possible.
General information and Safety advice
6
This equipment requires earthing.
BEFORE STARTING UP THE EQUIPMENT
Check that the equipment has not been damaged
. Do not use products which have been damaged during transport; if in
doubt consult the retailer or the manufacturer directly.
Use of the Osmo, as with any other equipment connected to an electrical system, involves compliance with certain fundamental safety rules:
•
do not touch the reverse osmosis purifying system with wet or damp hands or feet;
•
do not (dis)connect the plug to/from the socket with wet hands;
•
do not pull the power cord to disconnect the plug from the power outlet;
•
do not leave the reverse osmosis purifying system exposed to atmospheric agents;
•
do not allow the reverse osmosis purifying system to be used by children without supervision;
•
before carrying out any cleaning or maintenance operation, disconnect the reverse osmosis purifying system from the electricity mains
by taking out the plug from the power socket;
•
in the event of a fault or poor operation, switch off the Osmo and do not tamper with it. Contact an authorized technician for any intervention;
if parts of the reverse osmosis purifying system are replaced, for maintenance or due to a fault, by an unauthorized technician, make sure
the parts comply with the legislation in force.