3
INSTRUCTION
Activated charcoal installation
(not required if the water is used in a sterilizer):
1.
Remove the water dispenser from the safety cover by
pressing the two wings.
2.
Fold the activated charcoal sachet in half and put it into the
water dispenser.
3.
Reinstall the water dispenser onto the water outlet of the
safety cover.
Each activated charcoal sachet can be used for up to one month.
Pour water into the stainless steel tank
Use hot/cold water to fill the tank and make sure that you do not
go beyond the full line. If you use hot water, you can shorten the
time needed to distil water.
Starting up
Plug the mains cable into the socket
.
Secure the upper cover
and plug the power cord into the socket. Turn the mains switch
ON. Place the collection bottle and the protective cover in a
secure place and make sure they are levelled. Press the reset
button (when first used the button is automatically set in the
"on" position, so there is no need to switch it on for the very first
use).
The process starts when you press the reset button and it will
stop automatically at the end of the process. If you wish to
terminate the process, unplug the power cord.
The power supply is turned off automatically when the
distillation process is completed.
Approximately an hour after you have turned on the power
switch, the distilled water begins to drip down into the collection
bottle. It takes 5-6 hours to distil four litre of water.
When the power supply is cut off, you may move onto the next
tank immediately.
Distilled water
For proper storage place the distilled water in the refrigerator in
a sealed container. Before use shake the bottle to aerate the
water.
Activated
charcoal
sachet
Water dispenser
GB
Body
Reset button
Power cord
Mains switch
(I=On – 0=Off)
Mains cable socket
Power cord socket
Reset button
Collection
bottle
