WALTHER PILOT wa200, Руководство по эксплуатации

Страница: 19 / 26

10 Specification Data
Weight: 350 g
Connections:
Atomising Air G 1/8“ - PK 4
Control Air M 5 - PK 3
Material Inlet M 10 - 5 mm ø
Pressure Ranges:
Control Air Pressure max. 6 bar
Material Pressure max. 6 bar
max. Operating
Temperature
of Spray Gun
80° C
Sound Level
(measured at a distance
of 1 m from the spray gun) 83 dB(A)
Air Consumption:
1 bar Atomizing Air Input 50 L / min.
2 bar Atomizing Air Input 60 L / min.
3 bar Atomizing Air Input 70 L / min.
4 bar Atomizing Air Input 85 L / min.
5 bar Atomizing Air Input 90 L / min.
6 bar Atomizing Air Input 100 L / min.
Right to effect technical changes reserved.
8 Troubleshooting and Corrective Action
Warning
Prior to any servicing and repair work: Make sure that the spray gun is in unpressuri-
zed condition, i.e. all air and material inputs must be shut off - if not, imminent risk of
injury.
9 Disposal of Cleaning / Servicing Substances
Disposal of any such substances must be in accordance with all applicable local and
national regulations, directives and laws.
Warning
Pay special attention to all processing specifications and warnings issued by the manu-
facturer of spraying and cleaning media. The improper disposal of any toxic waste
material represents a serious thread to to environment, i.e. to the health of mankind
and animal life.
12 13
Fault Cause Corrective Action
Gun is dripping
Material needle or - nozzle
is fouled
Material needle or - nozzle
is damaged
Packing box is too tight
see 5.5 Removing Material Nozzle
and Needle and clean same
see 5.5 Replace Material Nozzle or
Needle
Loosen box slightly with a screw
driver
Gun fails to open
Control air pressure too low
Material needle is turned
too in
Increase Control Air Pressure to
max. 6 bar
Unscrew the notch of the spring
bushing pos. 24 (to the left)
Spray Jet pulsating
or unsteady Level in material tank too
low Top-up material level (see operating
instructions of plant systems manu-
facturer)
Gun sprays when
not in operation Cup seal pos. 17 or valve
spring pos. 23 are damaged Replace