Walter WWS-IGS1000, Оригинальная инструкция по эксплуатации

Страница: 76 / 216

Maintenance, cleaning, storage and transport
76
EN
• Remove the spark plug connector
12
with a slight upward turning
motion.
• Blow the power generator,
especially the area of the spark
plug, using compressed to remove
dust and dirt.
12
Cleaning and replacing the spark plug
• Place the generator on a flat surface.
• Unscrew the butterfly bolt
9
by hand and remove the motor cover
10
, to
open the side housing cover.
8
NOTICE!
Remove the spark plug only if dust or dirt can not get into the spark plug
opening.
• Turn the spark plug counter-clockwise using the spark plug spanner
7
.
• Check the condition of the spark plug:
−
If there is a lot of carbon deposit on the contacts, get in touch with a
technician or the manufacturer's service address mentioned on the
warranty card.
−
In case of light deposits, clean the contacts carefully with a copper wire
brush.
−
If necessary, replace the spark plug with a spark plug of the same type
(see chapter "Maintenance" and "Technical data").
0.6 - 0.7 mm
−
The distance between the
electrodes should be 0.6 - 0.7 mm.
Adjust them with a screwdriver if
necessary.