Wallpro CG-605L, Руководство по эксплуатации, Страница: 10 / 16

Tool Operation (continued)
For Cartridge Application
Fig. 7
Plunger Disk
Rack
Fig. 8
Fig. 9 Fig. 10
Fig. 11
Front Cap
M8 x 16 screw
Plastic Plunger Disk
Rack
Plunger Disc
Pushing Block
M8 x 16 screw
Rack
Plastic Plunger Disk
Plunger
Disk
Compound Holder
1. Firstly untighten and remove the compound holder.
2. Loosen M8 Screw (Fig.9) then remove the pushing block and plastic plunger disk (Fig10).
3.Screw back on the compound holder then remove the front cap.
4. Use a sharp knife to cut the tip of caulking tube at least 3 mm in diameter. This will allow the tool to
provide an optimum bead width to suit the application.
5. Insert the cartridge into the compound holder.
Screw the front cap on tight. It is not necessary to pull
back the rack by hand. Make sure the cartridge is
inserted properly and sits up tight on the steel head.
6. Push the rack rear knob forward to lock the rack
against the cartridge.