22
4.3 MACHINE BREAK-IN
Although there are no operational restrictions on
the Trailer Woodsplitter when used for the first
time, it is recommended that the following me-
chanical items be checked:
A�
After Operating For 1 and 5 Hours:
1� Check all nuts, bolts and other fasteners�
Tighten to their specified torque level�
2� Check hydraulic system for leaks� Tighten
all leaking fittings and replace any leaking
components�
3� Check machine fluid levels: Fuel, engine
oil, and hydraulic oil reservoir� Top up as
required�
4� Check for entangled material� remove all
entangled material before resuming work�
5� Check tire pressure� Inflate as required�
B�
After Operating For 10 Hours:
1� repeat steps 1 through 5 listed above�
2� Change engine oil�
3� Go to the normal servicing and mainte-
nance schedule as defined in the Mainte-
nance Section�
4.4 PRE-OPERATION CHECKLIST
efficient and safe operation of the Wallenstein
Trailer Woodsplitter requires that each operator
reads and understands the operating procedures
and all related safety precautions outlined in this
section� A pre-operation checklist is provided for
the operator� It is important for both the personal
safety and maintaining the good mechanical
condition of the Woodsplitter that this checklist is
followed�
Before operating the machine and each time
thereafter, the following areas should be checked
off:
1� Lubricate the machine per the schedule out-
lined in the Maintenance Section�
2� Check that the machine is properly attached
to the tractor or towing vehicle� Be sure
retainers are used through the drawbar pin or
ball hitch mechanism�
3� Check the wedge and block� Be sure they are
not damaged or broken and is not badly worn�
repair or replace as required�
4� Check for entangled material� remove this
material�
5� Check for hydraulic leaks� Tighten fittings or
replace components to stop leaks�
6� Check engine and machine fluid levels� Top
up as required�
