15
3 SAFETY SIGNS
1.
Keep safety signs clean and legible at all times,
2.
Replace safety signs that are missing or have become illegible.
3.
Replaced parts that displayed a safety sign should also display the current sign.
4.
Safety signs in Section 3 each have a part number displayed with it. Use this part number when ordering
replacement parts.
5.
Safety signs are available from your authorized Distributor or Dealer Parts Department or the factory.
Z94120
Z94117
Caution:
keep hands and feet out of inlet
and discharge openings while machine is
operating to avoid serious personal injury.
Wait for all moving parts to come to a
complete stop before clearing obstructions .
Caution:
machine is extremely
loud in operation. Hearing
protection is required or permanent
damage will occur. Lwa is sound
power level, Leq is the average
sound level.
Caution:
flying objects, be aware of and
Stay clear of material discharge chute,
machine can expel wood chips fast enough
to cause injury.
Do not point discharge at people, animals
or buildings.
Z94119
Caution:
read and understand ALL
safety
and operating instructions
in the manual,
read and understand ALL
safety labels
located on the machine. The most important
safety device on this equipment is an
informed SAFE operator.
3�2 SAFETY SIGN EXPLANATIONS:
3�1 HOW TO INSTALL SAFETY SIGNS:
•
Be sure that the installation area is clean and dry.
•
Be sure temperature is above 50°F (10°C).
•
Determine exact position before you remove the backing paper.
•
Remove the smallest portion of the split backing paper.
•
Align the sign over the specified area and carefully press the small portion with the exposed sticky
backing in place.
•
Slowly peel back the remaining paper and carefully smooth the remaining portion of the sign in place.
•
Small air pockets can be pierced with a pin and smoothed out using the piece of sign backing paper.
Caution:
Maximum size of material for
the chipper is 75 mm (3.0"). Attempting to
chip anything larger could stall the engine,
damage the chipper or cause personal
injury.
Caution:
rotating parts are exposed or
under a guard, do not attempt to reach in
while parts are turning. Keep hands, loose
clothing, and long hair away. Serious injury
will result.
Z94120
Z94117
75mm
3.0”
Z94232
Z94203
Z94127
Z94232
Z94127
Z94204
Caution:
Personal Protection
Equipment (PPE) is required
when operating this machine.
Failure to wear PPE will result in
personal injury
Z94116
Caution:
Do not operate machine without
shields in place, failure to do so may cause
serious injury or death Replace the shield
before operating equipment.
Z94201
19mm
0.75”
Z94201
Caution:
Maximum size of material for
the shredder is 19 mm (0.75"). Attempting
to shred anything larger could stall the
engine, damage the machine or cause
personal injury.
