14
3 SAFETY SIGNS
1.
Keep safety signs clean and legible at all times,
2.
Replace safety signs that are missing or have become illegible.
3.
Replaced parts that displayed a safety sign should also display the current sign.
4.
Safety signs in Section 3 each have a part number displayed with it. Use this part number when or
-
dering replacement parts.
5.
Safety signs are available from your authorized Distributor or Dealer Parts Department or the factory.
Caution:
keep hands and feet out of inlet
and discharge openings while machine is
operating to avoid serious personal injury.
Wait for all moving parts to come to a
complete stop before clearing obstructions .
Caution:
flying objects, be aware of and
Stay clear of material discharge chute,
machine can expel wood chips fast enough
to cause injury.
Do not point discharge at people, animals
or buildings.
Caution:
read and understand ALL
safety and operating instructions
in the
manual, read and understand ALL
safety
labels
located on the machine. The most
important safety device on this equipment
is an informed SAFE operator.
3�2 SAFETY SIGN EXPLANATIONS:
3�1 HOW TO INSTALL SAFETY SIGNS:
•
Be sure that the installation area is clean and dry.
•
Be sure temperature is above 50 °F (10 °C).
•
Determine exact position before you remove the backing paper.
•
Remove the smallest portion of the split backing paper.
•
Align the sign over the specified area and carefully press the small portion with the exposed sticky
backing in place.
•
Slowly peel back the remaining paper and carefully smooth the remaining portion of the sign in place.
•
Small air pockets can be pierced with a pin and smoothed out using the piece of sign backing paper
Caution:
Maximum size of material for
the chipper is 75 mm (3.0"). Attempting to
chip anything larger could stall the engine,
damage the chipper or cause personal
injury.
Caution:
rotating parts are exposed or
under a guard, do not attempt to reach in
while parts are turning. Keep hands, loose
clothing, and long hair away. Serious injury
will result.
Caution:
Maximum size of material for
the shredder is 25 mm (1.00"). Attempting
to shred anything larger could stall the
engine, damage the machine or cause
personal injury.
Caution:
Do not operate machine without
shields in place, failure to do so may
cause serious injury or death Replace the
shield before operating equipment.
Z94118
Caution:
rotating driveline, entanglement
danger present. Keep hands, loose
clothing, and long hair away from
driveline while it is rotating.
Caution:
when performing any
maintenance on the chipper ensure you
stop and disengage the PTO. Potential
for serious injury or death if the PTO is
not stopped and disengaged.
Z94241
25 mm
1"
Caution:
Ensure the drive line is rotating
in the proper direction at the rated RPM.
Z94240
540 RPM
1000 RPM
