Wallenstein 2E9US111XNS091454, Руководство оператора

Страница: 34 / 72

Operating Instructions
BXTR6438
Trailer Wood Chipper
34
5. Operating Instructions
CAUTION!
Hearing loss hazard. Prolonged
exposure to loud noise may cause
permanent hearing loss. Use suitable
protection while operating the
machine.
W016
The operator has the responsibility of being familiar with and
following all operating and safety procedures.
When operating this equipment always have at least two
workers present and trained in safe operation of the machine.
Although this machine is easy to use, each operator should
review this section to get familiar with the detailed safety and
operating procedures.
5.1 Before Startup
1. Check the engine oil level. See page 35.
2. Check the hydraulic oil level. See page 37.
3. Check the fuel level. See page 36.
4. Review the Safety Rules on page 8 .
5. Clear the area of bystanders.
6. Make sure each operator is trained and familiar with the set
up and operation of the wood chipper.
7. Perform the Pre-start checks.
8. Review the Controls (see page 20 ).
9. Survey the work site and place the chipper in a clear, level
work area.
10. Set up the machine correctly. See Machine Setup page
38 .
5.2 Pre-start Checks
Check the following each time the wood chipper is used:
Area to Check
Check the machine has been lubricated following the
schedule outlined in the Maintenance section.
Check the tension and alignment of the belts. Adjust
as required.
Check the rotor housing and discharge chute.
Remove any blockages, twine, wire or other material
that has become entangled.
Check the condition and clearance of the twig
breaker, rotor and stationary blades. Adjust or
replace as required.
Check condition of the battery and other electrical
components. Keep all components in good
condition.
Check for hydraulic leaks. Tighten connections or
replace components to stop leaks.
Check and ensure that all covers, guards and shields
are in place, secured, and can function as designed.
Check that all bearings are properly greased. Replace
if they do not turn freely.
Check and inspect tires, wheels, and hubs.
Check hydraulic fluid level. Top level up as required.
Check and tighten all fasteners. Make sure the
equipment is in good condition.