Wallenstein 2E9US111XNS091454, Руководство оператора

Страница: 35 / 72

BXTR6438
Trailer Wood Chipper
Operating Instructions
35
5.3 Machine Break-In
Although there are no operational restrictions on the wood
chipper when used for the first time, it is recommended that the
following mechanical items be checked:
After 1–5 hours of operation:
1. Review the engine operator's manual for break-in
information.
2. Inspect the axle, tires, and wheel hubs. Check wheel nut
torque.
3. Check tire pressure. Inflate as required.
4. Check sheave alignment. Re-align if required. See page
56.
5. Check belt tension. Adjust if required. See page 54 and
page 55.
6. Visually check condition of rotor bearings.
7. Check the condition and clearance of the twig-breaker, rotor
and ledger blades. Adjust as required.
8. Check for entangled material. Remove all entangled material
before resuming work.
9. Check condition of electrical and hydraulic components.
Keep all components in good condition.
10. Check all fluid levels. Top up as required.
11. Check torque on fasteners and hardware.
After 8 hours of operation:
12. Repeat all previous steps.
13. Check wheel bolt torque after 20–25 mi (32–40 km).
Regularly check weekly.
14. Perform all the checks in the Pre-start checks. See page
34.
5.4 Engine Oil Level Check
Check engine oil level daily. Check with the machine parked on
level ground and the engine stopped.
IMPORTANT! Running the engine with a low oil level can
cause engine damage that is not covered by warranty.
1. Make sure the engine is stopped, level, and is cool so the
oil has had time to drain into the sump.
2. Clean the area around the dipstick before removing it. This
helps to keep dirt out of the engine.
3. Remove the dipstick and wipe oil off. Reinsert the dipstick
into the tube until fully seated.
4. Remove dipstick and check oil level. The level should be
between the
F and L marks. If low (L), remove the oil fill
cap (2) and add oil of the proper type up to the F mark.
Reinstall oil fill cap and dipstick.
SAE 10W-30 is recommended for general use.
E
F
01569
1
2
Fig. 25 –
Checking Engine Oil Level
1. Oil Level Dipstick
2. Oil Filler Cap
Refer to the engine owner's manual included in the manual
tube for further information on engine oils.