wallas Spartan, Техническая информация

Страница: 6 / 43

Spartan
- 5 -
Installation
Heater installation
Country specific regulations shall be followed in any installation. The warranty of boat products is valid only in
installations that are done according to this manual. The device is meant for watercraft use. The warranty is not valid in
installations to vehicles or other spaces, ask country specific regulations from local distributor.
Things to note when selecting the installation location
The device shall be installed into a dry space in a protected location. The device must be mounted to a solid, stable
bulkhead, floor or wall. When installing, please note that the device needs to be removable for servicing. Connections
and location should be made so that the device can be easily disconnected for removal. For maintenance, it is useful to
leave 200 mm (7 7/8") empty space below the heater for the removal of the bottom cover of the heater.
The heater should be installed vertically level when the boat is on an even keel. The static inclination must not exceed
5°. While the device will tolerate being temporarily tilted to a steep angle (even for some hours), the burner will not yield
optimal performance if it is constantly inclined.
Select the place of installation to allow a minimum amount of bending in the warm air ducting. Avoid installing the
heater and control panel in the immediate vicinity of any potential water intrusion. If possible, install the control panel on
a vertical surface. We recommend that the device be installed by an authorized Wallas service shop or installer.
Things to note when installing pipes, hoses and cables
Power cables, warm air and fuel hoses must be protected in locations where they are susceptible to mechanical
damage due to sharp edges or heat. All cables and hoses should have a fluid precluding "drip loop" to prevent water or
other fluids from following wires or hoses to the heater.
Installation space
The device can be installed within the heated space or outside of it. If located unheated area, heating performance can
be improved by installing the an intake air tube to the heated space (warm return air). If located inside the heated area,
air refreshing performance can be improved by installing the an intake air tube to the outside air (cold, dry fresh air to
be heated).