Spartan
- 12 -
Note that unit doesn't work without 12V voltage to the "remote" pin, so its necessary to connect enable wire to
the main switch, or do a enable jumper instructed in section "24V system"
24 V direct current system
If the device is to receive power from a 24 V system, always connect a charging voltage reducer and a 12 V battery
before connecting the device. Without the battery the voltage reducer will not be enough on its own as it cannot
generate the large amount of current the glow plug requires. After the 12 V battery, the connection is the same as in a
12 V system. Note, if using remote wire, the remote wire also needs 12V, not 24V.
Only approved DC DC converter is Victron Orion 2412 - 25A, which can supply enough current without the voltage
drop.
Checking the connection
The device consumes most power when it is started up (glowing). At this point voltage losses are also at their highest.
During the glowing phase, the voltage must be at least 9,6 V measured at the quick coupling. See picture. If the voltage
is lower than this, the device may not start.
All wires needs to be mounted with smooth bending and equipped with strain relief.
Things to note about the connections
While installing, to make mounting and dismounting for service easier, it is recommended to leave some extra length of
loose cables and fuel line by creating a coil. If the installation location is cramped, it is recommend to connect the
cables and the fuel line to the device before mounting the unit to bracket. This will help the installation of device.
Содержание Spartan
